![]() ![]() Car Detailing and Show & Shine Prep sponsored by Autogeek.Car Audio & Electronics sponsored by Bavsound.Tire & Wheel Forum sponsored by The Tire Rack.Suspension Tech and Handling sponsored by.Professional Motorsports sponsored by Bimmerworld.Track, Auto-X & Drag Racing sponsored by.General BMW and Automotive Discussion sponsored by Intercity Lines. ![]() Quick Navigation Diagnostic Software Go Top There also appears to be other things that may or may not work, but let's just start there.Īgain, I've tried multiple installations and they all have similar errors with INPA. I guessed these codes where stopping the car regenning and it was stuck in a loop. Within a few miles drive I plugged in and checked again, they where back. The software is in a mini dvd that came with the package. The errors I'm getting throughout the process are either - ECU Subfunction Not Supported or EDIABAS Error 134: API-0014 depending on which part of the process I'm stepping through. Preparation Firstly I installed inpa software on my laptop. When I select I/O 1 I get errors and I have to click continue to get them to post up one by one. I click on status and then click on analog. I connect to e90, then select Engine and then MSS60. When I open INPA I get the two black circles. I registered the battery since replacing a new one yesterday.ġ. I can open Tool32 and load modules without issue. I coded out a door chime to experiment.Ģ. I can open NCSExpert and code without issue. It didnt seem like matt sensor, and it came back after clearing. The error was something like too high resistance. I've tried several different installations and similar errors seem to occur.ġ. I pulled the codes with INPA with laptop. I am having an issue that I would like some help on. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |